So ich hätte da mal ne Frage an die innovatek Jungs wegen einer Custom Made Halterung für den Graph-O-Matic
Der Graph-O-Matic soll mittels 4-Ösen Halterung auf ein Motherboard mit den Standard Ösen montierte werden.
sieht dann etwa so aus:
oder wenn etwas schöner auf nem Sockel 478 Board aussehen soll dann mit ner umgebauten G-Force Halterung so:
Da die Jungs von Asus mal wieder das grüne PCB des Chpisatzes gedreht haben, d.h. jetzt ist es wieder parallel zu Ösen und nicht wie auf den Bildern zu sehen um 45° gedreht sieht das mit dem Graph-O-Matic egal mit welcher Halterung etwas bescheiden aus.
meine Frage ist nun ob es bei innovatek möglich ist eine oder mehrere Blenden auf Kundenwunsch zu fertigen?
Im Klartext bedeutet das einfach anstatt die herkömmliche Verspannung be einer G-Force Halterung über die Ecken in eine Verspannung über die längsten Seiten zu versetzen. Dann wäre nämlich der Graph-O-Matic im montierten Zustand parallel zum grünen PCB und sieht einfach etwas besser und professioneller aus.
Dazu müßte man ja lediglich im CAD die Flansche versetzen und dann um's optimal zu machen gleich noch zwei Löcher im richtigen Abstand für die 4-Ösen Halterung setzen. Dann kann gelasert werden.
Also alles in allem wenn die CAD Daten vorhanden sind ne Sache von ner halben Stunde.
Ich hab keine Ahnung ob das jetzt jeder kapiert hat was ich da geschrieben hab.
Ich denke für innovatek wäre so etwas einfacher und kostengünstiger zu bewerkstelligen als wenn ich mich selber hinsetz die Halterung ausmesse und den Laser-Profi aufsuch.
Rene frag mal doch bitte nach ob sich so was machen lassen würde, vielleicht gibt's hier ja noch mal welche die auf so ne Halterung gewartet haben.