Sers Purschen!
Da ich eigenlich regelmäßig hier im Forum bin (ich lese lieber, als das
ich poste) hab ich mir gedacht ich muß euch mal mein Würfelchen
zeigen...
Angefangen hat das ganze vor 2 Jahren mit einem innovatek... mit dem
Flatflow und nem Singleradi..... mittlerweile sieht alles jedoch etwas
anders aus
So nun ein paar Bilder
Nun zur verbauten hardware:
CPU: AMD XP 2500@3200 @Zern Delta TR Plus
Motherboard: Abit NF7-S V2.0 @ Graph-o-matic
Arbeitsspeicher: 2x256MB Kingston HyperX PC3200 2-2-2-5-1
Grafikkarte: Saphire Radeon 9800Pro @ Graph-o-matic
SysHDD: 2xWD360 "Raptor" 10.000U/min @Raid0 @HDD-o-matic
DataHDD: Seagate Barracuda V 60GB 7200/U (wird durch ne größere
WD ersetzt und gewakt)
Netzteil: Enermax Aktiv PVC, 350 Watt (Fans replaced durch Pabst
NGLM)
DVD: Plextor PX116-A 16x Black
CD-RW: Plextor PX-W4824TA/Black 48x
DVD+R: NEC1100 flashed@ NEC1300A Black
Gehäuse: Yeong Yang Cube B0221
Lüfter: 1x 80mm Papst nglm, 1x92mm Pabst NGLM 3x Titan Alu (auf
den Radis) controlled by Fan-O-Matic
Radi:Heattransformer Radiator-X Dual, Konnvekt-o-matic, (hätte noch
nen innovatek single radi übrig vielleicht schraub ich den auch noch rein)
Pumpe: Eheim1046 geschirmt, per relais geschaltet
AB: Fass-o-matic (über den namen läßt sich streiten
)
Ich stehe eher auf schlichtes, cleanes Design deshalb ist alles in
schwarz/silber und würfelig gehalten. Weiters ist der Cube natürlich
komplett gedämmt. Zusätzlich verbaut ist jede Menge schlauch,
winkelverschraubungen , knickschutzfedern... Dafür nötig war ein wenig
blut und ne ordentliche Portion schweiß sowie lange nächte .... und
irgendwann mal ein Bandscheibenvorfall , denn das teil ist so was von
schwer
Naja viel kann ich nicht mehr machen... die Mosfet´s und das NT werden
noch gewakt... dann gehts zu meinem nächsten projekt nem Wassergekühlten
Shuttle....
P.s: Ich weiß es sind auch noch ein paar Teile von anderen Herstellern
verbaut, aber 85% der WaK kommt von innovatek... und wenn ihr fragt
wieso... ihr esst doch auch nicht jeden Tag bei Mutter?