Hallo,
irgendwas stimmt wieder nicht mit der DFS Anzeige, hier die Einstellungen:
Setup --> DFS Sensor -->
Alarm Message = 0.00l/min -->
Mainboard Signal = Off 0.00l/min -->
Relay1 Switch = 0.00l/min -->
Relay2 Switch = 0.00l/min -->
12V Switch = 0.00l/min -->
Display Mode = l/min -->
Pulses per Liter = 509 -->
Overview Mode = Off -->
Overviw Time = 1 Sec --> ESC
Monitor --> DFS Sensor -->
DFS Sensor = 0.61l/min -->
DFS Sensor = 3.66l/min -->
DFS Sensor = 0.00l/min --> ESC
Warum hat es 3 DFS Anzeigen mit unterschiedlichen Werten?
- Der Sensor ist am richtigen Ort eingesteckt
- Der Impulswert stimmt
- Die Einstellungen wurden am Fan-O-Matic gemacht und NICHT über die Software, diese zeigt immer noch 0.61l/min an egal welcher Impulswert.
Dazu kommen immer noch die !! ERROR ERROR !! 0x000 0x000 0x000 Meldungen, nach jedem Start, Neustart, An- und Abmelden, sowie Schalten der Lüfter. Die Fehlerausgabe für das Lüftertachosingnal ist überall auf "0".
Danke für Hilfe!
Gruss, Wolfgang
_________________ ABIT-IN9-32X|QX6700@3,33|Cellshock 1000Mhz 4GB|2x EVGA 8800 Ultra| MOR@ 2,He@tkiller, MIPS,HPPS,TOM,FOM Pro,AA DFS,Coollink|Galaxy 1000W|2x WD 10k 36GB, Raid0|1x WD 10k 150GB|NEC DVD RW Sata|2x NEC 90GX2 Pro|Logitech MX-5000|Stacker 830|Ultimate x64
|