Grosse Enttäuschung
Habe mir den Chieftec Big-Tower A/P geholt und habe ihm jetzt noch da Booster Kit spendiert.
Und nun etwas was ich sehr
Peinlich finde
Der Big-Tower hat Standfüsse zum 90° nach ausse drehn damit er stabiler steht. Auf der Seite wo der Konvektor dran häng auch dringend nötig, da bei der Wassermasse er "relativ" leicht kippen konnte. Nun ja war ja alles kein Porblem. Als ich den Booster anbauen wollte vielen mir folgende Dinge auf:
1.
Einen Fuss musste ich ein klappen da der Querstromlüfter sonst nicht gepasste hätte!!!
OK damit kann man leben, aber muss das?!?!
2.
Als ich das ganze wieder auf den Boden stellen wollte, ich hatte ihn auf der Tischkante platziert damit ich auch von unten ran kam,
ging es NICHT.
Der Querstromlüfter war nun ca 5mm tiefer als meine Gehäusefüsse.
Heißt also das der Konvektor von Werk nicht dafür vorgesehn war einen Bosster zu montieren.
WARUM???
Dachte eigentlich da alles aus einem Haus kommt das soetwas getestet wird.
Muster Gehäuse bauen oder so, wäre doch mal ein TIP!!!
Hab nun die nicht elegante Lösung und ein Laminat rest under das Gehäuse geschoben (6mm) nun steht die Kiste erstmal.
Ein enttäuschter Gruss
Hellpete