Also hab ich das richtig verstanden? : Das Programm hat dann einen disconnect, wenn eingestellete Werte erreicht wurden? Oder meintest du gerade was anderes damit, Rene?
Die Lüfter sind übrigens alle Papst Lüfter und von euch gekauft. Haben alle nen "Drehmesser" und werden im Programm alle angezeigt, nur dann nicht, wenn disconnect ist.
Wenn der Rechner ohne Programm läuft kommt relativ schnell der Fehler und bleibt, bis ich den "Enter Button" drücke.
Wenn ich dann die ganze Zeit die verschiedenen Werte ablese und hin und her springe bleibt die Anzeige normal, wenn ich sie in Ruhe lasse kommt der Fehler erst wieder.
Also bitte ein Tip, was ich da tun kann. So wie es jetzt ist finde ich es nämlich eher bescheiden....
Dafür habe ich mir nicht den FOM gekauft und soviel Geld investiert!
Der Vikinger