Hi,
hab heute mein Fan-O-Matic mit Bios 2.32 zurück bekommen. Habe auch ein Flow-Meter, weiss aber nicht ob Rev 2. Habe auch 232 p/l eingestellt.
Hatte vorher einen Durchfluss von ca. 0.4 -0.5. Jetzt zeigt er mir 0.46 an. Daher gehe ich davon aus das die eingestellten 232p/l korrekt sind.
Warum kann man da überhaupt was einstellen? Bei Einstellung 100 habe ich über 1l Durchfluss, was ja garnicht stimmt.
Noch eine Frage. Ist es normal das die Anzeige so langsam reagiert? Habe mal zum testen den Schlauch abgeklemmt und es hat 5sec gedauert
bis der Wert runtergegangen ist. Nach 15.sec hat er immer noch 0.2l angezeigt. Länger wollt ich dann nicht abklemmmen. Kann man da irgentwo
was einstellen das die Anzeige schneller reagiert?
Thx und Cu
|