*beam up*
(Gleicher Fred, anderes System)
Bin jetzt ja auch auf A64 umgestiegen und habe auch die Links in diesem Fred gelesen, ein paar Andere auch - schlauer bin aber ich deshalb nicht geworden!
Früher war alles besser: Multi x FSB = fertig war die Laube.
Nu rechnet man sich nen Wolf, um ein "paar Mhz" mehr rauszukitzeln!
C&Q ist unter der Energieverwaltung und im BIOS deaktiviert!
Mein System siehe Sig, hat folgende Einstellungen per
default :
- CPU-Multi : 12x
- LDT/HTT Multi: 5x
- "FSB"/HTT: 200 Mhz
Die einzelnen Takte sehen dann so aus:
- CPU-Takt: 12 x 200 (CPU-Multi x Referenztakt) = 2400 Mhz
- HTT-Takt: 5 x 200 (LDT-Multi x Referenztakt) = 1000 Mhz
- RAM-Takt: 2400 : 12 (CPU-Takt / RAM-Teiler bei "DDR 400") = 200 Mhz
Also, Sys läuft @ default und der RAM genau nach seinen Specs (DDR400)!
"Wissen" tu ich zudem folgendes:
- Der HTT-Takt soll die 1000 Mhz (default) nicht übersteigen, bzw. beim OC´en drunter bleiben.
- Der RAM an sich muss sich innerhalb seiner Specs bewegen, bzw. nur soweit übertaktet werden, wie er es verkraftet (je nach RAM-Specs).
Tolle Wurst!
Weitergesponnen würde dies ja heissen, dass, wenn ich folgende Einstellungen wähle, folgendes dabei rauskommt - und wichtig ist ja das, was hinten raus kommt !
- CPU- Multi: 12 x
- LDT/HTT Multi: 4 x
- "FSB"/HTT: 250 Mhz - keine Abhängigkeit zwischen Referenztakt und RAM-Takt!
Die einzelnen Takte würden dann so aussehen:
- CPU-Takt: 12 x 250 (CPU-Multi x Referenztakt) = 3000 Mhz
- HTT-Takt: 4 x 250 (LDT-Multi x Referenztakt) = 1000 Mhz
- RAM-Takt: 3000 : 15 (CPU-Takt / RAM-Teiler bei Auswahl "DDR 333") = 200 Mhz
Der HTT- und RAM-Takt würden hierbei, wie bei den "default-Einstellungen" laufen, also genau innerhalb dieser!
Die CPU würde mit 3 GHz getaktet sein!
Fragen:
-
Wo liegt der Fehler in der o.g. Rechnung, kriege die Möhre nämlich nicht gebootet (Mit CMOS clear duze ich mich inzwischen!
) und dass, bei 12xMulti,205 HTT,LDT 4x und 15 Teiler, was ja weit unter den Defaults liegt!