Hallo,
ich habe einen FlowMeter rev.2 und der Durchfluß liegt zwischen 0,4-0,5 l/min. Ich habe das Board per Powerswitch-Kabel mit dem FOM verbunden .
Wenn der PC eine Weile aus ist, habe ich Probleme ihn wieder zu starten.
Die Lüfter laufen ganz kurz an und das Licht des FOM leutet kurz auf, dann geht alles wieder aus, einerneutes Drücken des Powerschalters bringt nichts, ich muß den PC vom Netz trennen und das Spiel ein paar mal wiederholen, irgendwann startet er dann.
Wasser läuft (erst dachte ich die Pumpe braucht ne Weile, jetzt lasse ich sie immer an ohne dass sich was ändert).
Ich schätze das Signal vom FlowMeter ist nicht schnell genug da?
Wie kann ich das Problem beheben? Gibt es irgendwelche Einstellungen im FanControl dazu ?
Danke für jeden Hinweis.
gruß
Fred
|