Ich habe mir mal das Case angeschaut. Ist doch das selbe wie ein Silverstone SST-TJ06, oder?
Wenn ja, ist die Anordnung des Netzteils denkbar ungünstig gelöst, oder?
Man kann scheinbar nur NTs mit einem Lüfter verwenden, da der zweite (untere) Lüfter von dem HDD-Käfig versperrt wird.
Sonst hätte ich gedacht, einen Käfig selber aus Plexiglas zu bauen. Aber da das NT direkt auf dem HDD-Käfig sitzt, dürfte kaum Platz für die Materialstärke des Plexiglases sein. Vielleicht passt es aber, wenn Du die HDDs waagerecht einbaust. Dazu baust Du zwei Plexiglaskäfige nebeneinander, die jeweils zwei HDDs + HD-O-Matic enthalten. Müsstest Du mal messen, ob zwei Platten + Material (an den Seiten würde ich 4 - 6 mm nehmen) dort unterbringen kannst.
Gerade mal gemessen: Eine HDD ist 101mm breit *2 = 202 + Material (4*6mm) = 226 mm Minimum
Die Schrauben zur Befestigung der HD-O-Matics (
nicht im Lieferumfang des HD-O-Matic
) brauchen an den Seiten der HDD auch nochmal ca. 2 mm Platz. Dies dürfte aber mit den Schienen, mit denen die HDDs in das Case kommen, ausgeglichen werden. Ach ja, Achtung! Die Schienen musst Du natürlich mit messen bei der Breite der HDDs. Daher werden es wohl knapp 20 mm mehr werden die Du an Platz brauchst (246 mm Minimum)
Ohne Eigenbau klappt es wohl mit den vier HDDs + HD-O-Matic nicht. Mit den HDM L-Pro wohl erst Recht nicht.