Hallo an alle,
ich habe diese Durchflussmessturbine:
http://www.webshop-innovatek.de/assets/ ... ovatek.de/
und damit leider schon zum zweiten Mal Probleme, sie zeigt einen Durchfluss von 0 l/min an. Es ist schon die zweite, da die erste nach ca. 5 Monaten Betrieb exakt das selbe tat. Ich hatte daraufhin die alte umgetaucht und eine neue bekommen und hatte sofort wieder die alten Werte. Nun, nach weiteren ca. 5 Monaten wieder genau das selbe... von einem Tag auf den anderen: 0 l/min.
Dabei war nicht zu beobachten, dass der Durchfluss langsam geringer wurde. Von jetzt auf gleich: 0 l/min.
Ich habe jetzt schon einen Factory Reset gemacht, brachte keinerlei Erfolge. War auch damals nicht nötig, als ich den ersten gegen den zweiten Sensor tauschte.
Ich würde ja meinen, der Sensor ist defekt, doch im Support-Portal sagte man mir, dass der erste Sensor, den ich damals eingeschickt hatte, OK gewesen sei und das Problem bei mir liegen müsse. Man verweigert mir daher das Umtauschrecht.
Ich weiß momentan nicht, was ich tun kann. Hier meine Systemkonfig:
FOM Pro, angeschlossen über serielle Schnittstelle, Fan Control v. 4.0, Flowmeter rev. 2.0 in korrekter Flussrichtung integriert und WaKü bestend aus innovatek-Komponenten.
Temperaturen werden nach wie vor korrekt ausgelesen.
Vielen Dank!