Hallo Leute,
ich möchte meine Pumpe vom Netzteil des PCs lösen.
Warum? Bei jedem neustart schaltet mein P35C das Netzteil ab und der Kühlkreislauf bricht zusammen
(ich starte mehrfach am Tag neu)
Wenn der Venti abschaltet stört mich das nicht, aber ich will das die Pumpe läuft.
Jetzt war ich ganz schlau und habe mir einfach eine Eheim 1046 gekauft. Und leider stelle ich fest das meine HPPS wirklich nur so aussieht. Die 1046 baut nicht gescheit druck auf und wenn sie endlich mal läuft ist sie immernoch sehr viel lauter als die hpps
Ich also gestern die HPPS wieder eingebaut (Mist gehäuse umsonst angesägt für die Stromführung) und endlich höre ich dass die neue HDD auch leiser ist als die alte IBM.
Aber wie bekomme ich sie durchlaufend? Oder zumindest einen nachlauf von 10-20sec?
Mit dem Netzteil meines USB-IDE Adapters hat es nicht geklappt. Hat zwar üppige 2A auf 12V, aber die Pumpe läuft an, baut Druck auf und dann unterbricht das Netzteil und die Status-LED des selbigen blinkt => Vermutlich sicherheitsabschaltung.
HPPS Typ 5W @ 12V = 0,41A !?! Wo ist das Problem?
Alternativ hatte ich auch schon an eine Nachlaufsteuerung per Kondensator gedacht. 1F @ 12V gibts im CarHifi bereich für 40€. Plus Dioden und Ladewiederstand sollte da doch was zu machen sein.
Masse an Masse
+12V
Diode
Ladewiederstand um das NT beim Einschalten nicht zu überlasten
+Kondensator
Diode
+12V vom NT an welcher die HPPS hängt. Eine weitere Diode zwischen dieser Anschlusstelle und dem NT damit der Kondensator nach Abschalten nicht das NT Füttert.
Mächtig kompliziert das Ganze und auch nicht Billig.
Her mit euren Ideen und Kommentaren.
-----------------------------------------------------------------------------------
Mein System:
GA-P35C-DS3R, Pentium DC E2180@3.0, 1GB MDT@ 900MHZ, MSI 8600GT 512TDZ, Audigy Plat.EX, WD1600AAJS
Kühlkreislauf:
AGB-O-M -> HPPS+ -> GOM@Northbridge -> XX-FLow -> innovatek Radi -> Cape-Coolplex10 -> RETURN