Hi zusammen,
ich beabsichtige, im Januar folgendes System aufzusetzen:
Gehäuse - Eigenbau
MoBo - Supermicro X6DAL-TG
CPU - 2x Xeon X800 3,2GHz
RAM - 4x 1024
VGA - Matrox Parhelia 256PCI oder Matrox QID P256 Pro
Schnittkarte - Matrox RT100 Xtreme
TV - Hauppauge Nexus CA
Audio - SB Audigy 4 Pro
DVD-ROM
DVD-RW
HD1 - IDE 160GB
HD2 - SATA 250GB
HD3 - SATA 250GB
HD4 - SATA 250GB (HD2+3 als Raid 0)
So weit, so gut... aber da gerade beim Videoschnitt peinlich auf Rausch- und Brummtöne geachtet werden muss, sollte das Ganze weitestgehend geräuschfrei arbeiten.
Habe mir zu diesem Zweck mal folgende Parts in dieser Aufbaufolge zusammengesucht:
2x FlatFlow Xeon,
1x GOM für VGA,
4x HDOM Micro,
Flow,
Fass mit Fühler,
KOM-Ultra auf Füßen (als Beistellheizkörper
),
Single-Radi,
Inline-Fühler,
AGB,
HPPS,
FanOM,
Geschätzte 4 Meter Kreislauflänge.
Was fehlt? Genau, der Strom...
Frage 1: Suche noch ein empfehlenswertes geräuscharmes Netzteil mit ca. 600W? Evtl. 2 Stk. redundant, vielleicht sogar mit Wasserkühlung?
Frage 2: Will evtl. 2 HPPS mit AGB redundant in Reihe setzen. Ich weiß, die sind zuverlässig, aber spricht etwas dagegen? Ist das evtl. über die FanOM automatisch schaltbar?
Frage 3: Der Chipsatz wird bei diesen Boards normalerweise über die CPU-Lüfter mitgekühlt, das sollte aber mit passiven Speicherkühlern und zentral montiertem leisen Lüfter genügen, oder?
Frage 4: Genügt die Kühlleistung der Radiatoren, und eventuell auch noch für Wakü-Netzteil?
Frage 5: Die Schnellverschlusskupplugen (für den Passiv-Radi) haben wie's aussieht einen geringeren Innendurchmesser. Inwieweit beeinträchtigen die Dinger die Umwälzleistung?
Frage 6: Die beiden CPU auch auf jeden Fall in Reihe oder ist es da nicht besser, sie parallel anzupumpen?
Danke vorab,
mahe