Herb schafft immer noch...
Die Bilder sind halt schon wieder alt, einiges ist noch geändert
aber nun schaut euch den Salat an:
Gehäuse: CM Stackermaster
Netzteil: Netzteil-O-Tagic 480-U01
Mainboard: Asus A8N-SLI Deluxe
Grakas: 2 x Gainward Geforce 6800 Ultra Golden Sample
Prozzi: AMD 64 3500+ Winnie
Speicher: 2 x 1GB Infineon PC3200
DVD:
1Plextor 716A
1Plextor 708A
HD:
2xHitachi-IBM 200GB ATA
1xIBM-Hitachi 180GB ATA an SATA
2xHitachi 250GB SATA
ach, und meine geliebte uralte Hauppauge WinTV Theater.
Bin kein Casemodder, deshalb ist es mir auch ziemlich egal wie es innen aussieht,
außerdem habt ihr mal versucht bei 7 Laufwerken davon 5 in Wechselrahmen die Kabel zu
verstecken? Wegbeamen geht ja doch nicht.
Gekühlt werden NV4-Chipsatz + Hauptprozessor + beide Grakas.
Die Front ist in der Zwischenzeit fast komplett schwarz außer 708A.
Schreck lass nach, woher stammt nur der Name.
Das mit den Plastikdingern und den Gummibärchen dazwischen (oder wozu waren die sonst
dabei?) liegt mir nicht so. Hab die Unterseite hohl gedremelt und in die Originalbackplates
einfach 2.6mm Löcher gebohrt. Bis jetzt hälts gut.
Da isser der Schreihals, nerv…..
Noch´n Krampf - was treiben die da? Hab 10 Minuten mit einem Glasfaserradierer
den Kleber runtergeholt.
Danke an Netzteil-O-Tagic, sind ja schon viele Stromanschlüsse, haben trotzdem nicht gereicht,
deshalb die SATA-Kabel erweitert. Hab keine Y-Kabel da gehabt.
Der abgefräste und umgedrehte GOM 3 sieht nicht schön aus und ist
inzwischen durch die Uni-Halterung ersetzt.
die 2. Karte sauber eingepinselt…
und nun schon eingebaut, die Leitungen aus dem Gehäuse haben jetzt noch Schottverbinder
bekommen.
und er passt doch da rein, aufatmen.
Mein altes Titanium 250 mit , na ja, etwas lauterem als dem ASUS-Lüfter. Kompressor entkoppelt
und dann so einen Lüfter, verstehe ich beim besten Willen nicht. Gut geeignet zum
Fingernägel schneiden, die wachsen nie wieder nach.
Geregeltes Netzteil (Voltcraft PA600) hinter die Front gebaut und an die Steuerung angeschlossen.
den Dual-Radi Käfig zweckentfremdet, aber wieso, der macht ja immer noch dasselbe.
In der Zwischenzeit hab ich die Lüfter noch entkoppelt und den Radiator oben wieder
mit Blech verkleidet, sowie mit einer Eheim 1250 gekoppelt und im Bad versteckt.
Per Eigenbau-Kabel Rechner und Kühler am selben Hauptschalter und ich muss nicht
mehr aufstehen. Lässt sich von 4 bis 28 Grad regeln. Ab 15 und mehr Grad sollte
es ohne Kondenswasser funktionieren, je nach Zimmerklima.
So und nu ma Mecker....